Safety and Installation Information:
These 3D-printed climbing holds are designed for recreational use on properly constructed climbing walls only. Correct installation is essential; improper mounting may result in holds detaching, serious injury, or damage to your wall or equipment.
Always use all provided mounting hardware exactly where intended
Do not overtighten, Do not use impact guns
Use a wood screw to stop rotation and improve support
Do not substitute or omit bolts, washers, or screws
Install only on climbing walls rated for the intended load (minimum 3/4" / 18–19 mm plywood with proper backing)
Regularly inspect holds, bolts, and wall for wear, cracks, or loosening
These holds are not toys; adult supervision is required for children
Use at your own risk; climbing involves inherent dangers
By purchasing and installing these holds, you acknowledge and accept these risks.
